Manufacturers of Eco Friendly Cleaners and Sealants

Everstrong Nano-Poxy 2-Part Coating

$258.75

Everstrong Nano-Poxy Coating is a 2 part low VOC nano epoxy for commercial and residential use, engineered to withstand salt, abrasion, adhesion and corrosion.

LOW VOC

Salt Tolerant Nano Epoxy for:

PVC • Wood • Metal • Concrete

Semi-gloss Finish

1 GALLON

Technical Datasheet

Nano-Poxy Bangor Hangar Case Study

Everstrong Nano-Poxy Brochure

 

SKU: ES-107 Categories: , ,
Color

White

How to Apply

MIXING: Power mix contents of each container, making sure no pigment remains on the bottom. Pour a measured amount of part B into a clean container large enough to hold both components. Add an equal volume of part A to part B while under agitation. Continue agitation until the two components are thoroughly mixed. Do not use mixed material beyond pot life limits. Note: Both components must be above 60°F (16°C) prior to mixing. A large volume of material will set up quickly if not applied or reduced in volume.

APPLICATION: Surface must be clean, dry and free of oil, grease and other contaminants. Allow new concrete to cure for 28 days before application. Use appropriate tip/atomizing pressure for equipment, applicator technique and weather conditions. Brush: Recommended for small areas only. Use high quality natural synthetic bristle brushes. Note: Two or more coats may be required to obtain recommended film thicknesses.

CURING: Minimum 6 hours for handling. Curing time varies with surface temperature, air movement, humidity and film thickness. If more than 72 hours have elapsed between coats, the coated surface must be scarified before top coating.

Facts & Warnings

SAFE HANDLING AND USE INFORMATION:
Avoid breathing vapor mist or spray. Use with good ventilation. Gloves needed for extra sensitive skin. Use safety glasses or goggles to protect eyes. Rubber gloves and boots required. Wash hands and skin after each use.

Keep containers tightly closed when not in use. If mixture of A and B are allowed to remain in the mixing vessel past the pot life deadline, heat and a strong reaction will result. Grinding or other abrasive action to cured film may develop micro crystalline silica dust. Wear a dust mask during such operations.

Caution: Do not reseal mixed material. An explosion hazard may be created.

SPILL OR LEAK PROCEDURES
Avoid contact. Soak up with clay or other absorbent material. Place in covered container for disposal. Dispose in an approved incinerator or an approved landfill. Avoid elevated temperature.

POT LIFE: 2 ½ hours at 60°F (16°C) 1 ½ hours at 77°F (25°C) ¾ to 1 hour at 100°F (38°C)

SURFACE TEMPERATURE: Minimum 60°F (16°C) Maximum 135°F (57°C). The surface should be dry and at least 5°F (3°C) above the dew point. Coating will not cure below minimum surface temperature.

THINNING: Use No. 2 Thinner. For air spray, thin up to 10% or ¾ pint (380mL) per gallon. For airless spray or brush, thin up to 5% or ¼ pint (190mL) per gallon. Note: A maximum of 6% of No. 2 Thinner may be used to comply with VOC regulations.

CLEANUP: Flush and clean all equipment immediately after use with the recommended thinner, xylol or MEK.

Reviews


There are no reviews yet.

Be the first to review “Everstrong Nano-Poxy 2-Part Coating”