Manufacturers of Eco Friendly Cleaners and Sealants

Everstrong Rust Stop


Nano Technology Sealant for Metal Services.

Gloss finish


Everstrong Rust Stop is made for all ferrous and nonferrous metal surfaces. It is designed to prevent further rusting and oxidizing and provides a barrier against moisture.

SKU: ES-119 Categories: , ,

Watch The Video

Directions for Use

Do not dilute or alter packaged product. Mix well before using. No sanding of metal required, but wire brush lightly for best results. Clean off oil, dirt, increase before application. Use rubber gloves.

Application is recommended between 50°F to 90°F. Brush or sponge liberally, careful application will result in smooth finish.

Black coating will begin to develop in a few minutes. Two coats are usually required. Apply second coat after one to 2 hours.

Take only enough material from container to finish job. Do not return unused material to original product container. For long term protection and smooth finish, use sandable primer and paint. Do not sand black coating directly. Allow drying 24 hours before painting. Cleaned up with water and detergent.


Once product begins to dry surface will become black and smooth. If there is no rust present coating will remain clear. Depending on air temperature, cure time is between 2 to 4 hours. If painting surface after treatment allow for eight hours after final cure time before painting. Use solid or an epoxy based paint.

Clean up and storage

Wash surface with water and wipe dry. Store product at room temperature. Protect all nonmetal services like wood, glass, concrete, insulation and fiberglass.

Facts and warnings

Contains synthetic resin. Avoid contact with skin and eyes. In case of eye contact, flush eye with water for about 15 minutes and get prompt medical attention. In case of skin contact, wash off immediately with water. If swallowed, induce vomiting and call a position.



There are no reviews yet.

Be the first to review “Everstrong Rust Stop”