Manufacturers of Eco Friendly Cleaners and Sealants

Everstrong Traffic Zone Surface Marking Paint

$186.63

LOW VOC Traffic Zone Surface Marking Paint

Yellow Matte Finish

 Striping and Lane Marking for: Asphalt • Concrete • Driveways • Curbs • Parking Lots • Sidewalks • Airport Runways

1 GALLON

Technical Datasheet

SKU: ES-120 Categories: ,

Everstrong Traffic Zone Surface Marking Paint is an exceptionally durable, fast drying Nano Enhanced alkyd paint for striping and lane marking on asphalt or concrete, driveways, parking lots, sidewalks, curbs, or airport runways. This product has excellent hide and bleed resistance and dries to a gloss-free, highly visible, longer lasting finish.

How to Apply

Surface should be dry and free from oil, grease, dirt and other contaminants. Oil and grease can be removed from concrete with strong alkali cleaners or with solvent emulsion cleaners.

MIXING: Stir each container thoroughly before using.

Brush and continue Flow on a full wet coat. Do not brush back into partially set up coating. When using marking machines, follow instructions for specific machine used. Follow proper setting instructions. When spray applying use the following equipment recommendations as a guide:

AIRLESS SPRAY:

Tip . . . . . . . . . . . . . . . . . . . 013-.015″

Fan . . . . . . . . . . . . . . . . . 25°-60°

Pressure . . . . . . . . . . . . 1200-1600 PSI

COVERAGE: 150-250 square feet per gallon (14-23 square meters per 3.785 liters) or 600 to 700 lineal feet of four-inch wide line, depending on surface roughness. Approximate dry mil thickness of 4.6 to 2.8 mils at application rate of 150 to 250 square feet per gallon.

  • 1 Dry Mil: 768 sq. ft./gallon
  • Spread Rate: 400 sq. ft./gallon (4.0 mils wet)
  • Deposits a 1.9 mil dry film
  • VOC (g/l): Not to exceed 450
  • Viscosity: 82-87 K.U. @ 77° F.
  • Gloss @ 60: 10 Max, Flat
  • Grind (Hegman): #4-4.5
  • DOT Class: Flammable, Flash Point 57°F., UN1263
  • Federal Specification: N/A

Allow for overspray and surface irregularities. Film thickness is rounded to the nearest 0.5mil or 5 microns.

CLEANUP: Clean brushes and equipment with mineral spirits or VM&P Naphtha. Dispose of unused paint and waste in accordance with local, state and federal regulations.

Facts & Warnings

HMIS/NFPA: 1,3,0
Cure Time (Based on 70° F. & 50% R.H.):
To Touch: 10 Minutes
To Recoat: 60 Minutes

Temperature Resistance: Continuous 150° F., Intermittent 200° F.

WARNING! FLAMMABLE! Keep away from heat and open flame. Avoid prolonged contact with skin and breathing of vapor or spray mist. Do not take internally. Close container after each use. Use only with adequate ventilation.

KEEP OUT OF REACH OF CHILDREN. For specific safety requirements, refer to the Material Safety Data Sheet.

SPECIAL CAUTIONS: To obtain satisfactory dry, apply only when humidity is below 85% and temperature is above 50°F. Best drying speeds require 65°F. or above. On asphalt, a test patch should be made to check bleeding prior to painting. New asphalt surfaces occasionally must be allowed to cure and weather to prevent excessive bleeding through the dried paint.

Reviews


There are no reviews yet.

Be the first to review “Everstrong Traffic Zone Surface Marking Paint”